Supports the XBOX v1. 0-1. 6c, DUAL BIOS!
Compatible with aladdin family programmer;
Compatible with XBOX v1. 0-v1. 6c version;
Supports online games;
Play all backups
Play all homebrew
Play all original imports
Run Debug Executables
LBA48 Hack
Big HDD support
Embedded In Game Reset (IGR)
Compatible with all EvolutionX software
No-patch hack
Eject trick hack
Auto patch new media flag titles
Support for XBOX v1. 6
Works on all regions
Two boot modes; Off & On
Additional "D" bridge point
Socket for flash
Can be flashed (upgraded)
Open tool design
Duox3 Installation Diagrams Xbox Version 1.0 and 1.1 and 1.2
Install Duox3 for Xbox Version 1.3 and 1.4 and 1.5
Xbox Duox3 Installation / Duox3 Xbox Version 1.6a/1.6b/1.6c
LPC Rebuild 1.6 Xbox Main Bord Only (Underside of Main Board) 
Duox3 Completed Installation
Duox3 - XBOX - Standard Installation - Hold Power 2 Seconds to ARM Chip
1. Connect all 9 LPC Points - Either Method- eg. Direct Solder ( as shown ), Pin Headers or Wired.
2. Connect BT, DO and L1 Point on DuoX 3 to points shown on Xbox Main Board ( Connect The Dots with Wire )
3. Dont need - connect L2 - to M/B - also Known as Hard Drive Activity ( advise connecting L2 - on Xbox 1.6 )
4. Put small insulation barrier underside of chip ( Directly under points L2, L1, BT & DO - to prevent short )
5. Select Correct Switch Setting on DUOX 3 for Bios Bank Selection - Xbox 1.6 or all Other Xbox Versions
6. 1.6 Xbox Only - LPC Rebuild must be done on reverse side of Main Board
DuoX3 Installation Tips
DuoX3 xbox mod-chips can be installed 3 ways:
1) The preferred method is Direct Solder the main LPC points straight to the Xbox Main Board Contact Points - As Above
2) Position the DuoX3 modchip using Double sided Tape on the Xbox Main Board and use single strand Wire to connect to the Main Board LPC contact Points.
3) The least popular way is to use the pin headers that are packaged with the DuoX3 mod-chips.
Then to complete the installation use single strand wire to the main DuoX3 points (L1 , BT, L2, DO)
Duox3 - XBOX - Auto Boot Installation - DUOX 3 Chip Power on - Quick Tap
1. Connect all 9 LPC Points - Either Method- eg. Direct Solder ( as shown ), Pin Headers or Wired.
2. Connect BT Point on DuoX 3 to Ground - Any Ground on Xbox Main Board or any Ground on Duox3 Chip
3. Dont need - connect L1 - BT or L2 to M/B)
4. Put small insulation barrier underside of chip ( Directly under points L2, L1, BT & DO - to prevent short )
5. Select Correct Switch Setting on DUOX 3 for Bios Bank Selection -
6. 1.6 Xbox Only - LPC Rebuild must be done on reverse side of Main Board
| Total Rate： | Review Summary: 0 reviews | Write a review |
